Dell Force10 Z9000 - Ip Msdp Shutdown; Ip Multicast-Msdp

Version 8.3.7.0 Introduced on the S4810.
Version 7.5.1.0 Introduced on the E-Series.
Usage
Information
FTOS counts the SA messages originated by itself and those received from the MSDP peers.
When the total SA messages reach this limit, the subsequent SA messages are dropped (even
if they pass RPF checking and policy checking).
If the total number of SA messages is already larger than the limit when this command is
applied, those SA messages that are already in FTOS continue to be accepted. To enforce the
limit in such situation, use the clear ip msdp sa-cache command.
Related
Commands
ip msdp peer – configures the MSDP peer.
clear ip msdp peer – clears the MSDP peer.
show ip msdp – displays the MSDP information
ip msdp shutdown
Administratively shut down a configured MSDP peer.
E-Series, Z-Series, S4810
Syntax
ip msdp shutdown {peer address}
Parameters
peer address Enter the peer address in a dotted decimal format (A.B.C.D.).
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 6.2.1.1 Introduced
ip multicast-msdp
Enable MSDP.
E-Series, Z-Series, S4810
Syntax
ip multicast-msdp
To exit MSDP, use the no ip multicast-msdp command.
986