Dell Force10 Z9000 - Dot1 X Tx-Period; Show Dot1 X Cos-Mapping Interface

dot1x tx-period
Configure the intervals at which EAPOL PDUs the Authenticator PAE transmits.
C-Series, E-Series, S-Series, S4810
Syntax
dot1x tx-period seconds
To return to the default, use the no dot1x tx-period command.
Parameters
seconds Enter the interval time, in seconds, that EAPOL PDUs are transmitted.
The range is 1 to 65535. The default is 30.
Defaults 30 seconds
Command Modes INTERFACE
Command History
Version 8.3.12.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the C-Series and S-Series.
Version 7.4.1.0 Introduced on the E-Series.
show dot1x cos-mapping interface
Display the CoS priority-mapping table the RADIUS server provides and applied to authenticated supplicants on an
802.1X-enabled
C-Series, S-Series, S4810
Syntax
show dot1x cos-mapping interface interface [mac-address mac-
address]
Parameters
interface Enter one of the following keywords and slot/port or number
information:
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Fast Ethernet interface, enter the keyword
FastEthernet followed by the slot/port information.
• For a Ten-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
mac-address (Optional) MAC address of an 802.1X-authenticated supplicant.
Defaults none
206