Dell Force10 Z9000 - Show Ip Management-Route

down down
GigabitEthernet 1/1 unassigned NO Manual administratively
down down
GigabitEthernet 1/2 unassigned YES Manual
up up
GigabitEthernet 1/3 unassigned YES Manual
up up
GigabitEthernet 1/4 unassigned YES Manual
up up
GigabitEthernet 1/5 10.10.10.1 YES Manual
up up
GigabitEthernet 1/6 unassigned NO Manual administratively
down down
show ip management-route
View the IP addresses assigned to the Management interface.
C-Series, E-Series, Z-Series, S4810
Syntax
show ip management-route [all | connected | summary | static]
Parameters
all (OPTIONAL) Enter the keyword all to view all IP addresses assigned
to all Management interfaces on the switch.
connected (OPTIONAL) Enter the keyword connected to view only routes
directly connected to the Management interface.
summary (OPTIONAL) Enter the keyword summary to view a table listing the
number of active and non-active routes and their sources.
static (OPTIONAL) Enter the keyword static to view non-active routes
also.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Example
FTOS#show ip management-route
Destination Gateway State
820