Dell Force10 Z9000 - Service-Policy Output

NOTE: The service-policy commands are not allowed on a port channel. The
service-policy input policy-map-name command and the service-
class dynamic dot1p
command are not allowed simultaneously on an interface.
However, the service-policy input command (without the policy-map-name
option) and the service-class dynamic dot1p command are allowed on an
interface.
Related
Commands
policy-map-input – creates an input policy map.
service-policy output
Apply an output policy map to the selected interface.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
service-policy output policy-map-name
To remove the output policy map from the interface, use the no service-policy
output
policy-map-name command.
Parameters
policy-map-name Enter the name for the policy map in character format (16 characters
maximum). You can identify an existing policy map or name one that
does not yet exist.
Defaults none
Command Modes INTERFACE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the C-Series and S-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
A single policy-map can be attached to one or more interfaces to specify the service-policy for
those interfaces. A policy map attached to an interface can be modified.
Related
Commands
policy-map-output – creates an output policy map.
1212