Dell Force10 Z9000 - Show Crypto

Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
This command enables the SSH server and begins listening on a port. If a port is not specified,
listening is on SSH default port 22.
Example
FTOS# conf
FTOS(conf)# ip ssh server port 45
FTOS(conf)# ip ssh server enable
FTOS#
Related
Commands
show ip ssh – displays the ssh information.
show crypto
Display the public part of the SSH host-keys.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
NOTE: Some of the parameters in this command require licensing to access. For more
information, contact your Dell Force10 representative.
show crypto key mypubkey {rsa | rsa1}
Parameters
Key Enter the keyword key to display the host public key.
mypubkey Enter the keyword mypubkey to display the host public key.
rsa Enter the keyword rsa to display the host SSHv2 RSA public key.
rsa1 Enter the keyword rsa1 to display the host SSHv1 RSA public key.
NOTE: If you enable FIPS mode, this parameter is not available.
Defaults none
Command Modes EXEC
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
This command is useful if the remote SSH client implements Strict Host Key Checking. You can
copy the host key to your list of known hosts.
1333