Dell Force10 Z9000 - Show Config; Show Route-Map

Defaults Not configured.
Command Modes ROUTE-MAP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
If you do not use the set weight command, router-originated paths have a weight attribute
of 32768 and all other paths have a weight attribute of zero.
show config
Display the current route map configuration.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show config
Command Modes ROUTE-MAP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Example
FTOS(config-route-map)#show config
!
route-map hopper permit 10
FTOS(config-route-map)#
show route-map
Display the current route map configurations.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show route-map [map-name]
302