Dell Force10 Z9000 - Show Vlt Detail

Usage
Information
If you do not add a parameter such as arp or mac, the output displays all of the counters.
Example
FTOS# show vlt counter
Total VLT counters
-------------------------
L2 Total MAC-Address Count :
IGMP MRouter Vlans count :
IGMP Mcast Groups count :
ARP entries count :
Example (igmp-
snoop)
FTOS# show vlt counter igmp-snoop
Total IGMP VLT counters
----------------------
IGMP MRouter Vlans count : 1
IGMP Mcast Groups count : 5
Example (igmp-
snoop interface
port-channel)
FTOS#show vlt counter igmp-snoop interface port-channel 2
VLT Port-ID: 2 IGMP Counter
-----------------------
IGMP MRouter Vlans count : 0
IGMP Mcast Groups count : 5
FTOS# show vlt counter igmp-snoop interface port-channel 100
VLT Port-ID: 100 IGMP Counter
-----------------------
IGMP MRouter Vlans count : 1
IGMP Mcast Groups count : 0
Ve
show vlt detail
Displays detailed status information about VLT domains currently configured on the switch.
Z-Series, S4810
Syntax
show vlt detail
Default Not configured.
Command Modes EXEC
Command History
Version 9.0.0.0 Introduced on the Z9000.
Version 8.3.8.0 Introduced on the S4810.
Example
FTOS# FTOS(conf-if-vl-100)#show vlt detail
Local LAG Id Peer LAG Id Local Status Peer Status Active VLANs
------------ ----------- ------------ ------------
-------------
10 10 UP UP 100, 200, 300,
400,
1463