Parameters
kbps Enter the keyword kbps to specify the rate limit in Kilobits per
second (Kbps). On C-Series and S-Series, make the following value a
multiple of 64. The range is 0 to 10000000. The default granularity is
Megabits per second (Mbps).
rate
Enter the outgoing rate in multiples of 10 Mbps. The range is 10 to
10000.
burst-KB
(OPTIONAL) Enter the burst size in KB. The range is 0 to 10000. The
default is 10.
Defaults Granularity for rate is Mbps unless you use the kbps option.
Command Modes INTERFACE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Added the kbps option on the C-Series, E-Series, and S-Series.
Version 7.6.1.0 Introduced on the S-Series and C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
On 40-port 10G linecards, if the traffic is shaped between 64 and 1000 Kbs, for some values, the
shaped rate is much less than the value configured. Do not use values in this range for 10G
interfaces.
Related
Commands
rate-shape – shapes traffic output as part of the designated policy.
service-class bandwidth-percentage
Specify a minimum bandwidth for queues.
C-Series, S-Series, Z-Series
Syntax
service-class bandwidth-percentage queue0 number queue1 number
queue2 number queue3 number
Parameters
number
Enter the bandwidth-weight, as a percentage. The value must be a
power of 2. The range is 1 to 1024.
Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
1186
To Next Page
Loading...
