Dell Force10 Z9000 - Ip Msdp Default-Peer

Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.4.1.0 Introduced
Related
Commands
show ip msdp sa-cache rejected-sa
ip msdp default-peer
Define a default peer from which to accept all source-active (SA) messages.
E-Series, Z-Series, S4810
Syntax
ip msdp default-peer peer address [list name]
To remove the default peer, use the no ip msdp default-peer {peer address}
list
name command.
Parameters
peer address Enter the peer address in a dotted decimal format (A.B.C.D.)
list name Enter the keywords list name and specify a standard access list
that contains the RP address that should be treated as the default
peer. If no access list is specified, then all SAs from the peer are
accepted.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Added the list option and removed the prefix-list option.
Version 7.4.1.0 Introduced
Usage
Information
If a list is not specified, all SA messages received from the default peer are accepted. You can
enter multiple default peer commands.
980