Dell Force10 Z9000 - Neighbor Allowas-In; Neighbor Advertisement-Interval

Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced
Usage
Information
By default, when you create a neighbor/peer group configuration in the Router BGP context, it
is enabled for the IPv6/Unicast AFI/SAFI. By using activate in the new context, the neighbor/
peer group is enabled for AFI/SAFI.
neighbor advertisement-interval
Set the advertisement interval between BGP neighbors or within a BGP peer group.
C-Series, E-Series
Syntax
neighbor {ipv6-address | peer-group-name} advertisement-
interval seconds
To return to the default value, use the no neighbor {ipv6-address | peer-
group-name
} advertisement-interval command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
peer-group-name Enter the name of the peer group to set the advertisement interval for
all routers in the peer group.
seconds Enter a number as the time interval, in seconds, between BGP
advertisements. The range is 0 to 600 seconds. The default is 5
seconds for internal BGP peers and 30 seconds for external BGP
peers.
Defaults
• seconds = 5 seconds (internal peers)
• seconds = 30 seconds (external peers)
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced
neighbor allowas-in
Set the number of times an AS number can occur in the AS path.
C-Series, E-Series
Syntax
neighbor {ip-address | peer-group-name} allowas-in number
480