Dell Force10 Z9000 - Port-Channel-Protocol Lacp; Show Lacp

port-channel-protocol lacp
Enable LACP on any LAN port.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
port-channel-protocol lacp
To disable LACP on a LAN port, use the no port-channel-protocol lacp command.
Command Modes INTERFACE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 6.2.1.1 Introduced on the E-Series.
Related
Commands
show lacp – displays the LACP information.
show interfaces port-channel – displays information on configured Port Channel groups.
show lacp
Display the LACP matrix.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show lacp port-channel-number [sys-id | counters]
Parameters
port-channel-
number
Enter a port-channel number. For the C-Series and S-Series, the
range is 1 to 128. For the E-Series, the range is 1 to 255 for TeraScale
and 1 to 512 for ExaScale.
sys-id (OPTIONAL) Enter the keywords sys-id and the value that identifies
a system.
counters (OPTIONAL) Enter the keyword counters to display the LACP
counters.
Defaults Without a Port Channel specified, the command clears all Port Channel counters.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
912