Dell Force10 Z9000 - Debug Ip Msdp; Ip Msdp Cache-Rejected-Sa

Version 6.2.1.1 Introduced
debug ip msdp
Turn on MSDP debugging.
E-Series, Z-Series, S4810
Syntax
debug ip msdp {event peer address | packet peer address | pim}
To turn debugging off, use the no debug ip msdp {event peer address |
packet peer address | pim} command.
Parameters
event peer
address
Enter the keyword event followed by the peer address in a dotted
decimal format (A.B.C.D.).
packet peer
address
Enter the keyword packet followed by the peer address in a dotted
decimal format (A.B.C.D.).
pim Enter the keyword pim to debug advertisement from PIM.
Defaults Not configured.
Command Modes EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 6.2.1.1 Introduced
ip msdp cache-rejected-sa
Enable a MSDP cache for the rejected source-active entries.
E-Series, Z-Series, S4810
Syntax
ip msdp cache-rejected-sa {number}
To clear the MSDP rejected source-active entries, use the no ip msdp cache-
rejected-sa {number} command followed by the ip msdp cache-rejected-sa
{
number} command.
Parameters
number Enter the number of rejected SA entries to cache. The range is 0 to
32766.
979