Dell Force10 Z9000 - Show Storm-Control Unknown-Unicast

show storm-control unknown-unicast
Display the storm control unknown-unicast configuration.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show storm-control unknown-unicast [interface]
Parameters
interface (OPTIONAL) Enter one of the following interfaces to display the
interface specific storm control configuration:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/ port information.
• For a SONET interface, enter the keyword sonet followed by
the slot/port information.
• Fast Ethernet is not supported.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.5.1.0 Introduced on the E-Series.
Example (E-
Series)
FTOS#show storm-control unknown-unicast gigabitethernet 11/1
Unknown-unicast storm control configuration
Interface Direction Percentage Wred Profile
-------------------------------------------------
Gi 11/1 Ingress 5.9 -
Gi 11/1 Egress 5.7 w8
FTOS#
1404