Dell Force10 Z9000 - Interface

Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.2.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced.
interface
Configure the primary, secondary, and control-vlan interfaces.
C-Series, E-Series, S-Series, Z-Series
Syntax
interface {primary interface secondary interface control-vlan
vlan-id}
To return to the default, use the no interface {primary interface secondary
interface control-vlan vlan-id} command.
Parameters
primary interface Enter the keyword primary to configure the primary interface
followed by one of the following interfaces and slot/port information:
Fast Ethernet
interface:
enter the keyword FastEthernet
followed by the slot/port information
1-Gigabit
Ethernet
interface:
enter the keyword GigabitEthernet
followed by the slot/port information
Port Channel
interface:
enter the keyword port-channel
followed by a number:
• C-Series and S-Series Range: 1-128
• E-Series Range: 1 to 255 for
TeraScale and 1 to 512 for ExaScale
SONET interface: enter the keyword sonet followed by the
slot/port information
10-Gigabit
Ethernet
interface:
enter the keyword
TenGigabitEthernet followed by the
slot/port information
40-Gigabit
Ethernet
interface:
enter the keyword fortyGigE followed by
the slot/port information
secondary
interface
Enter the keyword secondary to configure the secondary interface
followed by one of the following interfaces and slot/port information:
642