Dell Force10 Z9000 - Lacp Long-Timeout; Lacp Port-Priority

Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.2.1.1 Introduced on the E-Series.
lacp long-timeout
Configure a long timeout period (30 seconds) for an LACP session.
C-Series, E-Series, S4810
Syntax
lacp long-timeout
To reset the timeout period to a short timeout (1 second), use the no lacp long-timeout
command.
Defaults 1 second
Command Modes INTERFACE (conf-if-po-number)
Command History
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.2.1.1 Introduced on the E-Series.
Usage
Information
This command applies to dynamic port-channel interfaces only. When applied on a static port-
channel, this command has no effect.
Related
Commands
show lacp – displays the lacp configuration.
lacp port-priority
Configure the port priority to influence which ports will be put in standby mode when there is a hardware limitation that
prevents all compatible ports from aggregating.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
lacp port-priority priority-value
To return to the default setting, use the no lacp port-priority priority-value
command.
909