Dell Force10 Z9000 - Match Tag

Defaults Not configured.
Command Modes ROUTE-MAP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Related
Commands
match interface – redistributes routes that match the next-hop interface.
match ip address – redistributes routes that match an IP address.
match ip next-hop – redistributes routes that match the next-hop IP address.
match ip route-source – redistributes routes that match routes advertised by other routers.
match metric – redistributes routes that match a specific metric.
match tag – redistributes routes that match a specific tag.
match tag
Configure a filter to redistribute only routes that match a specified tag value.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
match tag tag-value
To remove a match, use the no match tag command.
Parameters
tag-value Enter a value as the tag on which to match. The range is zero (0) to
4294967295.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
291