To disable quiet time, use the no dot1x quiet-time command.
Parameters
seconds
Enter the number of seconds. The range is 1 to 65535. The default is
30.
Defaults 30 seconds
Command Modes INTERFACE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the C-Series and S-Series.
Version 7.4.1.0 Introduced on the E-Series.
dot1x reauthentication
Enable periodic re-authentication of the client.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
dot1x reauthentication [interval seconds]
To disable periodic re-authentication, use the no dot1x reauthentication
command.
Parameters
interval
seconds
(Optional) Enter the keyword interval followed by the interval
time, in seconds, after which re-authentication will be initiated. The
range is 1 to 31536000 (1 year). The default is
3600 (1 hour).
Defaults 3600 seconds (1 hour)
Command Modes INTERFACE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the C-Series and S-Series.
Version 7.4.1.0 Introduced on the E-Series.
Related
Commands
interface range – configures a range of interfaces.
dot1x reauth-max
Configure the maximum number of times a port can re-authenticate before the port becomes unauthorized.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
dot1x reauth-max number
1320
To Next Page
Loading...
