name
The name you assign to the multiple spanning tree region.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
name region-name
To remove the region name, use the no name command.
Parameters
region-name
Enter the MST region name. The range is 32 character limit.
Defaults no default name.
Command Modes MULTIPLE SPANNING TREE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.5.1.0 Introduced.
Usage
Information
For two MSTP switches to be within the same MSTP region, the switches must share the same
region name (including matching case).
Related
Commands
msti – maps the VLAN(s) to an MST instance.
revision – assigns the revision number to the MST configuration.
protocol spanning-tree mstp
Enter MULTIPLE SPANNING TREE mode to enable and configure the multiple spanning tree group.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
protocol spanning-tree mstp
To disable the multiple spanning tree group, use the no protocol spanning-tree
mstp
command.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
997
To Next Page
Loading...
