Dell Force10 Z9000 - Show Ipv6 Neighbors

• For a Fast Ethernet interface, enter the keyword
fastEthernet followed by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel followed by a number. For the E-Series, the range
is 1 to 255 for TeraScale and 1 to 512 for ExaScale.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
hardware_addres
s
Enter a 48-bit hardware MAC address in nn:nn:nn:nn:nn:nn format.
Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.7.0 Introduced on the S4810.
show ipv6 neighbors
Display IPv6 discovery information. Entering the command without options shows all IPv6 neighbor addresses stored on
the control processor (CP).
E-Series, S4810
Syntax
show ipv6 neighbors [ipv6-address] [cpu {rp1 [ipv6-address] |
rp2 [ipv6-address]}] [interface interface]
Parameters
ipv6-address Enter the IPv6 address of the neighbor in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of
zero.
CPU Enter the keyword cpu followed by either rp1 or rp2 (Route
Processor 1 or 2), optionally followed by an IPv6 address to display
the IPv6 neighbor entries stored on the designated RP.
interface
interface
Enter the keyword interface followed by the interface type and
slot/port or number information:
• For a Fast Ethernet interface, enter the keyword
fastEthernet followed by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
1033