Dell Force10 Z9000 - Forward-Delay

Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.2.1.1 Introduced on the E-Series.
Related
Commands
protocol spanning-tree rstp – enters SPANNING TREE mode on the switch.
forward-delay
Configure the amount of time the interface waits in the Listening State and the Learning State before transitioning to the
Forwarding State.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
forward-delay seconds
To return to the default setting, use the no forward-delay command.
Parameters
seconds Enter the number of seconds that FTOS waits before transitioning
RSTP to the forwarding state. The range is 4 to 30. The default is 15
seconds.
Defaults 15 seconds
Command Modes CONFIGURATION RSTP (conf-rstp)
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.2.1.1 Introduced on the E-Series.
Related
Commands
hello-time – changes the time interval between BPDUs.
max-age – changes the wait time before RSTP refreshes the protocol configuration
information.
1276