Dell Force10 Z9000 - Show Mac-Address-Table

• For a Port Channel interface, enter the keywords port-
channel followed by a number. For the S-Series, the range
is 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
vlan vlan-id (OPTIONAL) Enter the keyword vlan followed by the VLAN ID to
display the MAC address assigned to the VLAN. The range is 1 to
4094.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
show mac-address-table
Display the MAC address table.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show mac-address-table [dynamic | static] [address mac-address
| interface interface | vlan vlan-id] [count [vlan vlan-id]
[interface interface-type [slot [/port]]]]
Parameters
dynamic (OPTIONAL) Enter the keyword dynamic to display only those MAC
addresses learned dynamically by the switch. Optionally, you can
also add one of these combinations:
address/mac-address,
interface/interface, or vlan vlan-id.
static (OPTIONAL) Enter the keyword static to display only those MAC
address specifically configured on the switch. Optionally, you can
also add one of these combinations:
address/mac-address,
interface/interface, or vlan vlan-id.
address mac-
address
(OPTIONAL) Enter the keyword address followed by a MAC
address in the nn:nn:nn:nn:nn:nn format to display information on that
MAC address.
interface
interface
(OPTIONAL) Enter the keyword interface followed by the
interface type, slot and port information:
931