Dell Force10 Z9000 - Page 903

Parameters
interface (OPTIONAL) Identifies the interface type slot/port as one of the
following:
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel
followed by a number. For the C-Series and S-
Series, the range is 1 to 128. For the E-Series, the range is 1 to
255 for TeraScale and 1 to 512 for ExaScale.
• For a SONET interface, enter the keyword sonet followed by
the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a VLAN, enter the keyword vlan followed by a number
from 1 to 4094.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.12.0 Introduced on the S4810.
Usage
Information
The following describes the show isis traffic command shown in the Example below.
Item Description
Level-1/Level-2
Hellos (sent/rcvd)
Displays the number of Hello packets sent and received.
PTP Hellos (sent/
rcvd)
Displays the number of point-to-point Hellos sent and received.
Level-1/Level-2 LSPs
sourced (new/
refresh)
Displays the number of new and refreshed LSPs.
Level-1/Level-2 LSPs
flooded (sent/rcvd)
Displays the number of flooded LSPs sent and received.
Level-1/Level-2 LSPs
CSNPs (sent/ rcvd)
Displays the number of CSNP LSPs sent and received.
Level-1/Level-2 LSPs
PSNPs (sent/ rcvd)
Displays the number of PSNP LPSs sent and received.
Level-1/Level-2 DR
Elections
Displays the number of times designated router elections ran.
Level-1/Level-2 SPF
Calculations
Displays the number of shortest path first calculations.
903