200.200.200.205
FTOS>
Usage
Infromation
The following describes the show vrrp command shown in the Example below.
Item Description
GigabitEthernet
12/3...
Displays the Interface, the VRRP group ID, and the network address.
If the interface is not sending VRRP packets, 0.0.0.0 appears as the
network address.
State: master... Displays the interface’s state:
• Na/If (not available)
• master (MASTER virtual router)
• backup (BACKUP virtual router)
the interface’s priority and the IP address of the MASTER.
Hold Down:... This line displays additional VRRP configuration information:
• Hold Down displays the hold down timer interval in seconds.
• Preempt displays TRUE if preempt is configured and FALSE if
preempt is not configured.
• AdvInt displays the Advertise Interval in seconds.
Adv rcvd:... This line displays counters for the following:
• Adv rcvd displays the number of VRRP advertisements
received on the interface.
• Adv sent displays the number of VRRP advertisements sent
on the interface.
• Gratuitous ARP sent displays the number of gratuitous ARPs
sent.
Virtual MAC address Displays the virtual MAC address of the VRRP group.
Virtual IP address Displays the virtual IP address of the VRRP router to which the
interface is connected.
Authentication:... States whether authentication is configured for the VRRP group. If it
is, the authentication type and the password are listed.
Tracking states.. This line is displayed if the track command is configured on an
interface. Below this line, the following information on the tracked
interface is displayed:
• Dn or Up states whether the interface is down or up.
• the interface type slot/port information.
Example
FTOS>show vrrp
------------------
GigabitEthernet 12/3, VRID: 1, Net: 10.1.1.253
State: Master, Priority: 105, Master: 10.1.1.253 (local)
Hold Down: 0 sec, Preempt: TRUE, AdvInt: 1 sec
1479
To Next Page
Loading...
