Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage 
Information
The forwarding table displays host route first, then displays route originated by routing protocol 
including static route.
The egress port section displays the egress port of the forwarding entry which is designated 
as:
• C for the Control Processor
• 1 for the Route Processor 1
• 2 for the Route Processor 2
If a link-local IPv6 address is statically configured and dynamically learned on a C-Series 
router, the dynamically-learned IPv6 address is displayed in the show ipv6 cam 
linecard
 output, but the statically-configured IPv6 address may not be displayed. Use the 
show ipv6 fib linecard or show ipv6 neighbors commands to display 
statically-configured addresses of IPv6 neighbors.
NOTE: If a route has a mask greater than 64, no output is displayed. Similarly, if there is 
more than one ECMP object with a destination route that has a mask greater than 64, if the 
first 64 bits in the destination routes of the ECMP objects are the same, only one route is 
installed in CAM even though multiple ECMP path entries exist.
Example (Fib)
FTOS#show ipv6 cam linecard 13 fib
Neighbor                Mac-Addr           Port    VId
-------------------------------------------------------
[ 31] 2002:44:1:1::11   00:00:01:1a:1e:d5   Gi 13/2  0
Prefix             Next-Hop           Mac-Addr Port   VId EC
------------------------------------------------------ 
[ 3147] 100::/64  [ 0] 2002:44:1:1::11   -    Gi 0/0   0 1
                  [ 0] 2002:44:1:24::11  -    Gi 0/0   0 1
                  [ 0] 2002:44:1:23::11  -    Gi 0/0   0 1
                  [ 0] 2002:44:1:21::11  -    Gi 0/0   0 1
                  [ 0] 2002:44:1:20::11  -    Gi 0/0   0 1
                  [ 0] 2002:44:1:19::11  -    Gi 0/0   0 1
FTOS#
Example
FTOS#show ipv6 cam linecard 1 port-set 0
Neighbor                           Mac-Addr           Port VId
--------------------------------------------------------------
[ 1768] 500::1                     00:00:00:00:00:00   CP  100
[ 2724] 700::1                     00:00:00:00:00:00   CP  0
[ 3016] fe80::201:e8ff:fe5a:e59e   00:00:00:00:00:00   CP  0
[ 3452] fe80::201:e8ff:fe5a:e21f   00:00:00:00:00:00   CP  0
846