Dell Force10 Z9000 - Page 1075

Parameters
process-id Enter the OSPF Process ID to show a specific process. If no Process
ID is entered, command applies only to the first OSPF process.
database-
summary
(OPTIONAL) Enter the keywords database-summary to the
display the number of LSA types in each area and the total number of
LSAs.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Added support of Multi-Process OSPF.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
The following describes the show ip ospf process-id database command shown
in the Example below.
Field Description
Link ID Identifies the router ID.
ADV Router Identifies the advertising router’s ID.
Age Displays the link state age.
Seq# Identifies the link state sequence number. This number allows you to
identify old or duplicate link state advertisements.
Checksum Displays the Fletcher checksum of an LSA’s complete contents.
Link count Displays the number of interfaces for that router.
Example
FTOS>show ip ospf 1 database
OSPF Router with ID (11.1.2.1) (Process ID 1)
Router (Area 0.0.0.0)
Link ID ADV Router Age Seq# Checksum Link count
11.1.2.1 11.1.2.1 673 0x80000005 0x707e 2
13.1.1.1 13.1.1.1 676 0x80000097 0x1035 2
192.68.135.2 192.68.135.2 1419 0x80000294 0x9cbd 1
Network (Area 0.0.0.0)
Link ID ADV Router Age Seq# Checksum
10.2.3.2 13.1.1.1 676 0x80000003 0x6592
10.2.4.2 192.68.135.2 908 0x80000055 0x683e
Type-5 AS External
Link ID ADV Router Age Seq# Checksum Tag
0.0.0.0 192.68.135.2 908 0x80000052 0xeb83 100
1075