link-state-id
(OPTIONAL) Specify LSA ID in dotted decimal format. The LSA ID
value depends on the LSA type, and it can be one of the following:
• the network’s IP address for Type 3 LSAs or Type 5 LSAs
• the router’s OSPF router ID for Type 1 LSAs or Type 4 LSAs
• the default destination (0.0.0.0) for Type 5 LSAs
adv-router
ip-
address
(OPTIONAL) Enter the keywords adv-router followed by the IP
address of an Advertising Router to display only the LSA information
about that router.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Added support for Multi-Process OSPF.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
The following describes the show ip ospf process-id database summary
command shown in the Example below.
Item Description
LS Age Displays the LSA age.
Options Displays the optional capabilities available on router. The following
options can be found in this item:
• TOS-capability or No TOS-capability is displayed depending
on whether the router can support Type of Service.
• DC or No DC is displayed depending on whether the
originating router can support OSPF over demand circuits.
• E or No E is displayed on whether the originating router can
accept AS External LSAs.
LS Type Displays the LSA type.
Link State ID Displays the Link State ID.
Advertising Router Identifies the router ID of the LSA’s originating router.
LS Seq Number Displays the link state sequence number. This number allows you to
identify old or duplicate LSAs.
Checksum Displays the Fletcher checksum of an LSA’s complete contents.
1089
To Next Page
Loading...
