Parameters
process-id
Enter the OSPF Process ID to show a specific process. If no Process
ID is entered, command applies only to the first OSPF process.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 9.1(0.0) Deprecated command on the S4810 and Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Added support for Multi-Process OSPF.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
The following describes the show ip ospf process-id virtual-links command
shown in the Example below.
Items Description
“Virtual Link...” This line specifies the OSPF neighbor to which the virtual link was
created and the link’s status.
“Run as...” This line states the nature of the virtual link.
“Transit area...” This line identifies the area through which the virtual link was
created, the interface used, and the cost assigned to that link.
“Transmit Delay...” This line displays the transmit delay assigned to the link and the
State of the OSPF neighbor.
“Timer intervals...” This line displays the timer values assigned to the virtual link. The
timers are Hello is hello-interval, Dead is dead-interval, Wait is
transmit-delay, and Retransmit is retransmit-interval.
“Hello due...” This line displays the amount of time until the next Hello packet is
expected from the neighbor router.
“Adjacency State...” This line displays the adjacency state between neighbors.
Example
FTOS#show ip ospf 1 virt
Virtual Link to router 192.168.253.5 is up
Run as demand circuit
Transit area 0.0.0.1, via interface GigabitEthernet 13/16,
Cost of using 2
Transmit Delay is 1 sec, State POINT_TO_POINT,
Timer intervals configured, Hello 10, Dead 40, Wait 40,
Retransmit 5
Hello due in 00:00:02
FTOS#
1100
To Next Page
Loading...
