Command Modes
• EXEC
• EXEC Privilege
Command History
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
The following describes the show interfaces rate limit command shown in the
Example below.
Field Description
Rate limit Committed rate (Mbps) and burst size (KB) of the committed rate.
peak Peak rate (Mbps) and burst size (KB) of the peak rate.
Traffic monitor 0 Traffic coming to class 0.
Normal Committed rate (Mbps) and burst size (KB) of the committed rate.
peak Peak rate (Mbps) and burst size (KB) of the peak rate.
Out of profile Yellow Number of packets that have exceeded the configured committed
rate.
Out of profile Red Number of packets that have exceeded the configured peak rate.
Traffic monitor 1 Traffic coming to class 1.
Traffic monitor 2 Traffic coming to class 2.
Traffic monitor 3 Traffic coming to class 3.
Traffic monitor 4 Traffic coming to class 4.
Traffic monitor 5 Traffic coming to class 5.
Traffic monitor 6 Traffic coming to class 6.
Traffic monitor 7 Traffic coming to class 7.
Total: yellow Total number of packets that have exceeded the configured
committed rate.
Total: red Total number of packets that have exceeded the configured peak
rate.
Example (Rate
Limit)
FTOS#show interfaces gigabitEthernet 1/1 rate limit
Rate limit 300 (50) peak 800 (50)
Traffic Monitor 0: normal 300 (50) peak 800 (50)
Out of profile yellow 23386960 red 320605113
Traffic Monitor 1: normal NA peak NA
Out of profile yellow 0 red 0
Traffic Monitor 2: normal NA peak NA
Out of profile yellow 0 red 0
Traffic Monitor 3: normal NA peak NA
Out of profile yellow 0 red 0
Traffic Monitor 4: normal NA peak NA
Out of profile yellow 0 red 0
Traffic Monitor 5: normal NA peak NA
Out of profile yellow 0 red 0
1189
To Next Page
Loading...
