Dell Force10 Z9000 - Page 1224

• For a SONET interface, enter the keyword sonet followed by
the slot/ port information.
• For a Ten Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
interface Enter one of the following keywords and slot/port or number
information:
• On the C-Series and E-Series, For a Fast Ethernet interface,
enter the keyword FastEthernet followed by the slot/port
information.
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a SONET interface, enter the keyword sonet followed by
the slot/ port information.
• For a Ten Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.1 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
You can use the show qos statistics command on the C-Series, but the keyword
wred-profile must be omitted in the syntax. The show qos statistics output
command differs from the ED and EE series line cards and the EF series line cards. The QoS
statistics for the EF series generates two extra columns, Queued Pkts and Dropped Pkts
(Example 2).
1224