Dell Force10 Z9000 - Page 1260

variable Enter the MIB object to monitor. The variable must be in the SNMP
OID format; for example, 1.3.6.1.2.1.1.3. The object type must be a 32
bit integer.
interval Time, in seconds, the alarm monitors the MIB variables; this is the
alarmSampleType in the RMON alarm table. The range is 5 to 3600
seconds.
delta Enter the keyword delta to test the change between MIB variables.
This is the alarmSampleType in the RMON alarm table.
absolute Enter the keyword absolute to test each MIB variable directly.
This is the alarmSampleType in the RMON alarm table.
rising-threshold
value event-
number
Enter the keywords rising-threshold followed by the value (32
bit) the rising-threshold alarm is either triggered or reset. Then enter
the event-number to trigger when the rising threshold exceeds its
limit. This value is the same as the alarmRisingEventIndex or
alarmTable of the RMON MIB. If there is no corresponding rising-
threshold event, the value is zero.
falling-threshold
value event-
number
Enter the keywords falling-threshold followed by the value
(32 bit) the falling-threshold alarm is either triggered or reset. Then
enter the event-number to trigger when the falling threshold exceeds
its limit. This value is the same as the alarmFallingEventIndex or the
alarmTable of the RMON MIB. If there is no corresponding falling-
threshold event, the value is zero.
owner string (OPTIONAL) Enter the keyword owner followed by the owner name
to specify an owner for the alarm. This is the alarmOwner object in
the alarmTable of the RMON MIB.
Defaults owner
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.1.1.0 Introduced on the E-Series.
1260