• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
• For a VLAN interface, enter the keyword vlan followed by a
number from 1 to 4094.
tos
(IPv4 only) Enter the type of service required. Range: 0-255. Default: 0.
df-bit
(IPv4 only) Enter Y or N for the “don't fragment” bit in IPv4 header.
• N: Do not set the “don't fragment” bit.
• Y: Do set “don't fragment” bit
Default is No.
validate-reply
(IPv4 only) Enter Y or N for reply validation.
• N: Do not validate reply data .
• Y: Do validate reply data .
Default is No.
outgoing-
interface
(IPv6 link-local address) Enter the outgoing interface for ping packets
to a destination link-local address.
pattern
pattern
(IPv4 only) Enter the IPv4 data pattern. Range: 0-FFFF. Default:
0xABCD.
sweep-min-size
Enter the minimum size of datagram in sweep range. Range: 52-15359
bytes.
sweep-max-size
Enter the maximum size of datagram in sweep range. Range: 53-15359
bytes.
sweep-interval
Enter the incremental value for sweep size. Range: 1-15308 seconds.
ointerface
(IPv4 only) Enter the outgoing interface for multicast packets. Enter
the IP address in A.B.C.D format.
• For an 100/1000 Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Port Channel, enter the keyword port-channel
followed by a number. For the C-Series and S-Series: the
range is 1 to 128. For the E-Series: the range is 1 to 255 for
TeraScale and 1 to 512 for ExaScale.
• E-Series only For the SONET interfaces, enter the keyword
sonet followed by slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
127
To Next Page
Loading...
