Dell Force10 Z9000 - Page 1396

Message ID Trap Type Trap Option
%RPM0-P:CP %SNMP-4-RMON_HC_RISING_THRESHOLD: RMON
high-capacity rising threshold alarm from SNMP OID
<oid>
RMON_HC_FALLING_THRESHOLD SNMP NONE
%RPM0-P:CP %SNMP-4-RMON_HC_FALLING_THRESHOLD: RMON
high-capacity falling threshold alarm from SNMP OID
<oid>
RESV NONE NONE
N/A
CHM_CARD_DOWN ENVMON NONE
%CHMGR-1-CARD_SHUTDOWN: %sLine card %d down - %s
%CHMGR-2-CARD_DOWN: %sLine card %d down - %s
CHM_CARD_UP ENVMON NONE
%CHMGR-5-LINECARDUP: %sLine card %d is up
CHM_CARD_MISMATCH ENVMON NONE
%CHMGR-3-CARD_MISMATCH: Mismatch: line card %d is
type %s - type %s required.
CHM_CARD_PROBLEM ENVMON NONE
CHM_ALARM_CUTOFF ENVMON NONE
CHM_SFM_UP ENVMON NONE
CHM_SFM_DOWN ENVMON NONE
CHM_RPM_UP ENVMON NONE
%RAM-6-RPM_STATE: RPM1 is in Active State
%RAM-6-RPM_STATE: RPM0 is in Standby State
CHM_RPM_DOWN ENVMON NONE
%CHMGR-2-RPM_DOWN: RPM 0 down - hard reset
%CHMGR-2-RPM_DOWN: RPM 0 down - card removed
CHM_RPM_PRIMARY ENVMON NONE
%RAM-5-COLD_FAILOVER: RPM Failover Completed
%RAM-5-HOT_FAILOVER: RPM Failover Completed
%RAM-5-FAST_FAILOVER: RPM Failover Completed
CHM_SFM_ADD ENVMON NONE
%TSM-5-SFM_DISCOVERY: Found SFM 1
CHM_SFM_REMOVE ENVMON NONE
%TSM-5-SFM_REMOVE: Removed SFM 1
CHM_MAJ_SFM_DOWN ENVMON NONE
%CHMGR-0-MAJOR_SFM: Major alarm: Switch fabric down
CHM_MAJ_SFM_DOWN_CLR ENVMON NONE
1396