NOTE: This option is supported on the E-Series only.
linecard (OPTIONAL) Enter the keyword linecard followed by either all or
the slot number to display traffic statistics on the designated line
card.
NOTE: This option is supported on the C-Series only.
rp1 (OPTIONAL) Enter the keyword rp1 to display traffic statistics on the
RP1.
NOTE: This option is supported on the E-Series only.
rp2 (OPTIONAL) Enter the keyword rp2 to display traffic statistics on the
RP2.
NOTE: This option is supported on the E-Series only.
Defaults all
Command Modes EXEC
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series
Version 6.2.1.1 Introduced on the E-Series.
Usage
Information
Traffic statistics are sorted on a per-interface basis; the interface receiving the most traffic is
displayed first. All CPU and port information is displayed unless a specific port or CPU is
specified. Traffic information is displayed for router ports only; not for management interfaces.
The traffic statistics are collected only after the debug cpu-traffic-stats command is
executed; not from the system bootup.
NOTE: After debugging is complete, use the no debug cpu-traffic-stats
command to shut off traffic statistics collection.
Example
FTOS#show cpu-traffic-stats
Processor : CP
--------------
Received 100% traffic on GigabitEthernet 8/2 Total packets:100
LLC:0, SNAP:0, IP:100, ARP:0, other:0
Unicast:100, Multicast:0, Broadcast:0
Processor : RP1
---------------
Received 62% traffic on GigabitEthernet 8/2 Total packets:500
LLC:0, SNAP:0, IP:500, ARP:0, other:0
Unicast:500, Multicast:0, Broadcast:0
Received 37% traffic on GigabitEthernet 8/1 Total packets:300
LLC:0, SNAP:0, IP:300, ARP:0, other:0
Unicast:300, Multicast:0, Broadcast:0
Processor : RP2
---------------
No CPU traffic statistics.
FTOS#
141
To Next Page
Loading...
