To disable debugging, use the no debug vrrp interface [vrrp-id] {all |
database| interface| packets | state | timer} command.
Parameters
interface
Enter the following keywords and slot/port or number information
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For Port Channel interface types, enter the keywords port-
channel
followed by the number. For the C-Series and S-
Series, the range is 1 to 128. For the E-Series, the range is 1 to
255 for TeraScale.
• For a 40-Gigabit Ethernet interface, enter the keyword
FortyGigabitEthernet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a VLAN interface, enter the keyword vlan followed by
the VLAN ID. The VLAN ID range is from 1 to 4094.
vrrp-id
(OPTIONAL) Enter a number from 1 to 255 as the VRRP group ID.
all Enter the keyword all to enable debugging of all VRRP groups.
database Enter the keyword database to enable configuration to change
information.
interface Enter the keyword interface to enable interface state to
information.
packets Enter the keyword packets to enable debugging of VRRP control
packets.
state Enter the keyword state to enable debugging of VRRP state
changes.
timer Enter the keyword timer to enable debugging of the VRRP timer.
Command Modes EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Usage
Information
If no options are specified, debug is active on all interfaces and all VRRP groups.
1473
To Next Page
Loading...
