Dell Force10 Z9000 - Page 151

show linecard
output Field
Description
Next Boot Displays whether the line card is to be brought online at the next
system reload.
Required Type Displays the line card type configured for the slot. The Required Type
and Current Type must match. If they do not match, use the
linecard command to reconfigure the line card type.
Current Type Displays the line card type installed in the slot. The Required Type
and Current Type must match. If they do not match, use the
linecard command to reconfigure the line card type.
Hardware Rev Displays the chip set revision.
Num Ports Displays the number of ports in the line card.
Up Time Displays the number of hours and minutes the card is online.
FTOS Version Displays the operating software version.
Jumbo Capable Displays Yes or No indicating if the line card can support Jumbo
frames.
Boot Flash Ver Displays the two possible Bootflash versions. The [Booted] keyword
next to the version states which version was used at system boot.
Memory Size List the memory of the line card processor.
Temperature Displays the temperature of the line card. Minor alarm status if the
temperature is over 65° C.
Power Status Lists the type of power modules used in the chassis:
• AC = AC power supply
• DC = DC Power Entry Module (PEM)
Voltage Displays OK if the line voltage is within range.
Serial Number Displays the line card serial number.
Part Num Displays the line card part number.
Vendor ID Displays an internal code, which specifies the manufacturing
vendor.
Date Code Displays the line card’s manufacturing date.
Example (E-
Series)
FTOS#show linecard 11
-- Line card 11 --
Status : online
Next Boot : online
Required Type : E48PF - 48-port GE line card with SFP optics
(EF)
Current Type : E48PF - 48-port GE line card with SFP optics
(EF)
Hardware Rev : Base - 1.0 PP0 - n/a PP1 - n/a
Num Ports : 48
Up Time : 12 hr, 37 min
FTOS Version : 6.2.1.x
151