Dell Force10 Z9000 - Page 173

show rpm
output Field
Description
RP2 Boot Flash Displays the two possible Boot Flash versions for the Routing
Processor 2. The [Booted] keyword next to the version states which
version was used at system boot.
CP Mem Size Displays the memory of the control processor.
RP1 Mem Size Displays the memory of the Routing Processor 1.
PR2 Mem Size Displays the memory of the Routing Processor 2.
Temperature Displays the temperature of the RPM. Minor alarm status if the
temperature is over 65°C.
Power Status Lists the status of the power modules in the chassis.
Voltage Displays the power rails for the line card.
Serial Num Displays the line card serial number.
Part Num Displays the line card part number.
Vendor ID Displays an internal code, which specifies the manufacturing
vendor.
Date Code Displays the line card’s manufacturing date.
Country Code Displays the country of origin. 01 = USA.
Example (E-
Series)
FTOS#show RPM 0
-- RPM card 0 --
Status : active
Next Boot : online
Card Type : RPM - Route Processor Module (LC-EF-RPM)
Hardware Rev : 2.0
Num Ports : 1
Up Time : 36 min, 51 sec
Last Restart : reset
FTOS Version : 6.2.1.0
Jumbo Capable : yes
CP Boot Flash : A: 2.4.0.6 B: 2.4.0.7 [booted]
RP1 Boot Flash: A: 2.4.0.7 [booted] B: 2.4.0.5
RP2 Boot Flash: A: 2.4.0.7 [booted] B: 2.4.0.5
CP Mem Size : 536870912 bytes
RP1 Mem Size : 0 bytes
RP2 Mem Size : 0 bytes
Temperature : 49C
Power Status : PEM0: absent or down PEM1: up
Voltage : ok
Serial Number : 0016788
Part Number : 7520013800 Rev 01
Vendor Id : 01
Date Code : 06182004
Country Code : 01
FTOS#
Related
Commands
show chassis – view information on all elements of the system.
show linecard – view information on a line card.
173