Usage
Information
Without the linecard or page option, the command output is continuous. Uuse CNTL-z to
interrupt the command output.
The save option works with other filtering commands. This allows you to save specific
information of a
show command. The save entry must always be the last option. For example:
FTOS#show tech-support |grep regular-expression |except
regular-expression | find regular-expression | save flash://
result
This display output is an accumulation of the same information that is displayed when you
execute one of the following show commands:
• show cam-profile
• show cam-ipv4flow
• show chassis
• show clock
• show environment
• show file-system
• show interface
• show inventory
• show ip management-route
• show ip protocols
• show ip route summary
• show processes cpu
• show processes memory
• show redundancy
• show rpm
• show running-conf
• show sfm
• show version
Example (C-
Series)
FTOS#show tech-support page
----------- show version --------------------------
Dell Force10 Networks Real Time Operating System Software
Dell Force10 Operating System Version: 1.0
Dell Force10 Application Software Version: FTOS 7.5.1.0
Copyright (c) 1999-2007 by Force10 Networks, Inc.
Build Time: Tue Sep 12 15:39:17 IST 2006
Build Path: /sites/maa/work/sw//C-SERIES/SW/SRC
Dell Force10 uptime is 18 minutes
System image file is "/work/sw/IMAGES/Chassis/C300-ODC-2/FTOS-
CS.bin"
Chassis Type: C300
Control Processor: IBM PowerPC 750FX (Rev D2.2) with
1073741824 bytes of memory.
128K bytes of non-volatile configuration memory.
1 Route Processor/Switch Fabric Module
2 48-port GE 10/100/1000Base-T line card with RJ45 interface
(CB)
1 FastEthernet/IEEE 802.3 interface(s)
180
To Next Page
Loading...
