ip-protocol-
number
Enter a number from 0 to 255 to deny based on the protocol identified
in the IP protocol header.
source
Enter the IP address of the network or host from which the packets
were sent.
mask
Enter a network mask in /prefix format (/x) or A.B.C.D. The mask,
when specified in A.B.C.D format, may be either contiguous or
noncontiguous.
any Enter the keyword any to specify that all routes are subject to the
filter.
host
ip-address
Enter the keyword host and then enter the IP address to specify a
host IP address.
destination
Enter the IP address of the network or host to which the packets are
sent.
count (OPTIONAL) Enter the keyword count to count packets that the filter
processes.
byte (OPTIONAL) Enter the keyword byte to count bytes that the filter
processes.
log (OPTIONAL, E-Series only) Enter the keyword log to enter ACL
matches in the log.
dscp (OPTIONAL) Enter the keyword dcsp to match to the IP DCSCP
values.
order (OPTIONAL) Enter the keyword order to specify the QoS priority for
the ACL entry. The range is 0 to 254 (where 0 is the highest priority
and 254 is the lowest; lower-order numbers have a higher priority). If
you do not use the keyword
order, the ACLs have the lowest order
by default (255).
monitor (OPTIONAL) Enter the keyword monitor when the rule is describing
the traffic that you want to monitor and the ACL in which you are
creating the rule is applied to the monitored interface. For more
information, refer to the “Flow-based Monitoring” section in the Port
Monitoring chapter of the
FTOS Configuration Guide
.
fragments Enter the keyword fragments to use ACLs to control packet
fragments.
Defaults Not configured.
Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Add the DSCP value for ACL matching.
Version 8.2.1.0 Allows ACL control of fragmented packets for IP (Layer 3) ACLs.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
227
To Next Page
Loading...
