creating the rule is applied to the monitored interface. For more
information, refer to the section “Flow-based Monitoring” in the Port
Monitoring chapter of the
FTOS Configuration Guide
.
fragments Enter the keyword fragments to use ACLs to control packet
fragments.
Defaults Not configured.
Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST
Command History
Version 8.3.1.0 Added the keyword dscp.
Version 8.2.1.0 Allows ACL control of fragmented packets for IP (Layer 3) ACLs.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Added support for non-contiguous mask and added the monitor
option.
Version 6.5.1.0 Expanded to include the optional QoS order priority for the ACL
entry.
Usage
Information
The order option is relevant in the context of the Policy QoS feature only. For more
information, refer to the Quality of Service chapter of the
FTOS Configuration Guide
.
The monitor option is relevant in the context of flow-based monitoring only. For more
information, refer to the Port Monitoring chapter.
When you use the log option, the CP processor logs details the packets that match.
Depending on how many packets match the log entry and at what rate, the CP may become
busy as it has to log these packets’ details.
NOTE: When ACL logging and byte counters are configured simultaneously, byte counters
may display an incorrect value. Configure packet counters with logging instead.
ICMP Message Type
Keywords
ICMP Message Type Name
administratively-
prohibited
Administratively prohibited
alternate-address Alternate host address
conversion-error Datagram conversion error
dod-host-prohibited Host prohibited
dod-net-prohibited Net prohibited
echo Echo
echo-reply Echo reply
general-parameter-
problem
Parameter problem
host-isolated Host isolated
233
To Next Page
Loading...
