EasyManua.ls Logo

Dell Force10 Z9000 - Page 261

Dell Force10 Z9000
1483 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
dscp (OPTIONAL) Enter the keyword dcsp to match to the IP DCSCP
values.
order (OPTIONAL) Enter the keyword order to specify the QoS order for
the ACL entry. The range is 0 to 254 (where 0 is the highest priority
and 254 is the lowest; lower order numbers have a higher priority). If
you do not use the keyword
order, the ACLs have the lowest order
by default (255).
monitor (OPTIONAL) Enter the keyword monitor when the rule is describing
the traffic that you want to monitor and the ACL in which you are
creating the rule is applied to the monitored interface.
NOTE: For more information, refer to the Flow-based Monitoring
section in the Port Monitoring chapter of the
FTOS Configuration
Guide
.
fragments Enter the keyword fragments to use ACLs to control packet
fragments.
Defaults Not configured
Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Add the DSCP value for ACL matching.
Version 8.2.1.0 Allows ACL control of fragmented packets for IP (Layer 3) ACLs.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 Added support for the non-contiguous mask and added the
monitor option. Deprecated the keyword established.
Version 6.5.10 Expanded to include the optional QoS order priority for the ACL
entry.
Usage
Information
The monitor option is relevant in the context of flow-based monitoring only. For more
information, refer to Port Monitoring.
The order option is relevant in the context of the Policy QoS feature only. The following
applies:
The seq sequence-number command is applicable only in an ACL group.
The order option works across ACL groups that have been applied on an interface
via the QoS policy framework.
The order option takes precedence over seq sequence-number.
If sequence-number is not configured, the rules with the same order value are
ordered according to their configuration order.
261

Table of Contents

Other manuals for Dell Force10 Z9000

Related product manuals