Dell Force10 Z9000 - Page 393

Parameters
ipv4 unicast (OPTIONAL) Enter the keywords ipv4 unicast to view
information only related to ipv4 unicast routes.
community-list-
name
Enter the name of a configured IP community list (max 16 characters).
exact-match Enter the keyword for an exact match of the communities.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
The show ip bgp community-list command without any parameters lists BGP routes
matching the Community List and the output is the same as for the show ip bgp command
output.
The following describes the show ip bgp community-list pass command shown in
the Example below.
Field Description
Network Displays the destination network prefix of each BGP route.
Next Hop Displays the next hop address of the BGP router. If 0.0.0.0 is listed in
this column, then local routes exist in the routing table.
Metric Displays the BGP route’s metric, if assigned.
LocPrf Displays the BGP LOCAL_PREF attribute for the route.
Weight Displays the route’s weight.
Path Lists all the ASs the route passed through to reach the destination
network.
Example
FTOS#show ip bgp community-list pass
BGP table version is 0, local router ID is 10.101.15.13
Status codes: s suppressed, d damped, h history, * valid, >
best
Path source: I - internal, a - aggregate, c - confed-external,
r - redistributed, n - network
Origin codes: i - IGP, e - EGP, ? - incomplete
Network Next Hop Metric LocPrf Weight Path
FTOS#
393