peer-group-name
(OPTIONAL) Enter the name of a peer group to view information about
that peer group only.
detail (OPTIONAL) Enter the keyword detail to view detailed status
information of the peers in that peer group.
summary (OPTIONAL) Enter the keyword summary to view status information
of the peers in that peer group. The output is the same as that found
in the
show ip bgp summary command.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.8.0 Added the add-path option to the S4810. Output on the S4810
shows the ADDPATH parameters.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
The following describes the show ip bgp peer-group command shown in the Example
below.
Line beginning with: Description
Peer-group Displays the peer group’s name.
Administratively shut Displays the peer group’s status if the peer group is not enabled. If
you enable the peer group, this line is not displayed.
BGP version Displays the BGP version supported.
Minimum time Displays the time interval between BGP advertisements.
For address family Displays IPv4 Unicast as the address family.
BGP neighbor Displays the name of the BGP neighbor.
Number of peers Displays the number of peers currently configured for this peer
group.
Peer-group
members:
Lists the IP addresses of the peers in the peer group. If the address
is outbound optimized, an * is displayed next to the IP address.
Example (S4810)
FTOS#show ip bgp peer-group
Peer-group pg1
BGP version 4
Minimum time between advertisement runs is 30 seconds
For address family: IPv4 Unicast
BGP neighbor is pg1
Number of peers in this group 4
Update packing has 4_OCTECT_AS support enabled
411
To Next Page
Loading...
