To copy a file on
the external
FLASH
enter slot0:// followed by the filename
To copy a file on
a TFTP server
enter tftp://hostip/filepath
ExaScale only:
To copy a file
from a USB drive
on RPM0
enter rpm0usbflash://filepath
To copy a file
from an external
USB drive
enter usbflash://filepath
Command Modes EXEC Privilege
Command History
Version 8.4.1.0 Added IPv6 addressing support for FTP, TFTP, and SCP.
Version 8.2.1.0 Added usbflash and rpm0usbflash commands on E-Series
ExaScale
Version 7.6.1.0 Introduced on the S-Series and added the SSH port number to the
SCP prompt sequence on all systems.
Version 7.5.1.0 Introduced on the C-Series
E-Series Original command
Usage
Information
FTOS supports a maximum of 100 files at the root directory level, on both the internal and
external Flash.
The usbflash and rpm0usbflash commands are supported on E-Series ExaScale
platform only. For a list of approved universal serial bus (USB) vendors, refer to the FTOS
Release Notes.
When copying a file to a remote location (for example, using Secure Copy [SCP]), enter only the
keywords and FTOS prompts you need for the rest of the information. For example, when using
SCP, you can enter copy running-config scp: where running-config is the
source and the target is specified in the ensuing prompts. FTOS prompts you to enter any
required information, as needed for the named destination—remote destination, destination
filename, user ID, password, etc.
When you use the copy running-config startup-config command to copy the
running configuration (the startup configuration file amended by any configuration changes
made since the system was started) to the startup configuration file, FTOS creates a backup
file on the internal flash of the startup configuration.
FTOS supports copying the running-configuration to a TFTP server or to an FTP server. For
example:
•
copy running-config tftp:
•
copy running-config ftp:
Example
FTOS#copy running-config scp:/
Address or name of remote host []: 10.10.10.1
65
To Next Page
Loading...
