Dell Force10 Z9000 - Page 703

• For a SONET interface, enter the keyword sonet followed by
the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
• For a VLAN, enter the keyword vlan followed by a number
from 1 to 4094.
Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.2.1.0 Added support for 4093 VLANs on E-Series ExaScale. Prior releases
supported 2094.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
When creating an interface range, interfaces appear in the order they are entered; they are not
sorted. The command verifies that interfaces are present (physical) or configured (logical).
Important Things to Remember:
• Bulk configuration is created if at least one interface is valid.
• Non-existing interfaces are excluded from the bulk configuration with a warning
message.
• The interface range prompt includes interface types with slot/port information
for valid interfaces. The prompt allows for a maximum of 32 characters. If the bulk
configuration exceeds 32 characters, it is represented by an ellipsis ( ... ).
• When the interface range prompt has multiple port ranges, the smaller port
range is excluded from the prompt.
• If overlapping port ranges are specified, the port range is extended to the smallest
start port and the biggest end port.
Example (Bulk)
FTOS(conf)#interface range so 2/0-1, te 10/0, gi 3/0, fa 0/0
% Warning: Non-existing ports (not configured) are ignored by
interface-range
Example (Multiple
Ports)
FTOS(conf)#interface range gi 2/0 - 23, gi 2/1 - 10
FTOS(conf-if-range-gi-2/0-23#
703