Key Description
systest-3 Displays the host name assigned to the system.
monitor time Displays the amount of time since the monitor interface
command was entered.
time Displays the amount of time the chassis is up (since last reboot).
m Change the view from a single interface to all interfaces on the line
card or visa-versa.
c Refresh the view.
b Change the counters displayed from Packets on the interface to
Bytes.
r Change the [delta] column from change in the number of packets/
bytes in the last interval to rate per second.
l Change the view to the next interface on the line card, or if in line
card mode, the next line card in the chassis.
a Change the view to the previous interface on the line card, or if in
line card mode, the previous line card in the chassis.
T Increase the screen refresh rate.
t Decrease the screen refresh rate.
q Return to the CLI prompt.
Example (Single
Interface)
systest-3 Monitor time: 00:00:06 Refresh Intvl.: 2s Time:
03:26:26
Interface: Gi 0/3, Enabled, Link is Up, Linespeed is 1000 Mbit
Traffic statistics: Current Rate Delta
Input bytes: 9069828 43 Bps 86
Output bytes: 606915800 43 Bps 86
Input packets: 54001 0 pps 1
Output packets: 9401589 0 pps 1
64B packets: 67 0 pps 0
Over 64B packets: 49166 0 pps 1
Over 127B packets: 350 0 pps 0
Over 255B packets: 1351 0 pps 0
Over 511B packets: 286 0 pps 0
Over 1023B packets: 2781 0 pps 0
Error statistics:
Input underruns: 0 0 pps 0
Input giants: 0 0 pps 0
Input throttles: 0 0 pps 0
Input CRC: 0 0 pps 0
Input IP checksum: 0 0 pps 0
Input overrun: 0 0 pps 0
Output underruns: 0 0 pps 0
Output throttles: 0 0 pps 0
m - Change mode c - Clear screen
l - Page up a - Page down
712
To Next Page
Loading...
