mac {dest-mac |
source-dest-mac
| source-mac}
Enter the keywords to distribute MAC traffic based on the following
criteria:
• dest-mac — Uses the destination MAC address, VLAN,
Ethertype, source module ID and source port ID fields to
hash. The hashing mechanism returns a 3-bit index indicating
which port the packet should be forwarded.
• source-dest-mac — Uses the destination and source
MAC address, VLAN, Ethertype, source module ID and source
port ID fields to hash. The hashing mechanism returns a 3-bit
index indicating which port the packet should be forwarded.
• source-mac — Uses the source MAC address, VLAN,
Ethertype, source module ID and source port ID fields to
hash. The hashing mechanism returns a 3-bit index indicating
which port the packet should be forwarded.
tcp-udp enable Enter the keywords to distribute traffic based on the following:
• enable — Takes the TCP/UDP source and destination ports
into consideration when doing hash computations. (By
default, this is
enabled.)
ingress-port
enable
Enter the keywords to distribute traffic based on the following:
• enable — Takes the source port into consideration when
doing hash computations. (By default, this is disabled.)
Defaults IP 4-tuple (IP SA, IP DA, Source Port, Destination Port)
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.10.0 Added the ingress-port parameter for the S4810.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Usage
Information
By default, FTOS distributes incoming traffic based on a hash algorithm using the following
criteria:
• IP source address
• IP destination address
• TCP/UDP source port
• TCP/UDP destination port
Related
Commands
hash-algorithm ecmp – changes the hash algorithm across an ECMP.
798
To Next Page
Loading...
