Dell Force10 Z9000 - Page 812

Field Description
Port Displays the egress interface. Use the second half of the entry to
determine the interface. For example, in the entry 17cl CP, the CP is
the pertinent portion.
• CP = control processor
• Gi = Gigabit Ethernet interface
• Te = 10 Gigabit Ethernet interface
Example
FTOS#show ip cam stack-unit 0 port-set 0 10.10.10.10/32 longer-
prefixes
Destination EC CG V C VId Mac-Addr Port
----------------- -- -- - ------ --------------------
10.10.10.10 0 0 1 1 0 00:00:00:00:00:00 3f01 CP
FTOS#
Usage
Information
The following describes the show ip cam ecmp-group command shown in the Example
below.
Field Description
Prefix Length Displays the prefix-length or mask for the IP address configured on
the linecard 0 port pipe 0.
Current Use Displays the number of routes currently configured for the
corresponding prefix or mask on the linecard 0 port pipe 0.
Initial Size Displays the CAM size allocated by FTOS for the corresponding
mask. The CAM size is adjusted by FTOS if the number of routes for
the mask exceeds the initial allocation.
Example (ECMP-
Group)
FTOS#show ip cam stack-unit 0 po 0 ecmp-group detail
Destination EC CG V C VId Mac-Addr Port ECMP Group-Index
----------------- -- -- - ----- ---------------- -------------
1.1.1.2 0 0 1 0 0 00:01:e8:8a:d6:58 0004 Te 0/3 -
2.1.1.2 0 0 1 0 0 00:01:e8:8a:d6:58 0009 Te 0/8 -
1.1.1.1 0 0 1 1 0 00:00:00:00:00:00 3f01 CP -
2.1.1.1 0 0 1 1 0 00:00:00:00:00:00 3f01 CP -
1.1.1.0 0 0 1 1 0 00:00:00:00:00:00 3f01 CP -
2.1.1.0 0 0 1 1 0 00:00:00:00:00:00 3f01 CP -
100.1.1. 0 1 0 1 0 0 00:01:e8:8a:d6:58 0004 Te 0/3 0
100.1.1. 0 1 0 1 0 0 00:01:e8:8a:d6:58 0009 Te 0/8 0
0.0.0.0 0 0 1 1 0 00:00:00:00:00:00 3f01 CP -
FTOS#
Example
(Member-Info)
FTOS#show ip cam stack-unit 0 po 0 ecmp-group member-info
detail
Group Index Member Count Mac-Addr Port VLan ID Gateway
----------- ------------------------------- ------------------
0 2 00:01:e8:8a:d6:58 Te 0/3
0 1.1.1.2
00:01:e8:8a:d6:58 Te 0/8 0 2.1.1.2
FTOS#
812