Dell Force10 Z9000 - Page 823

mask (OPTIONAL) Specify the network mask of the route. Use this
parameter with the IP address parameter.
longer-prefixes (OPTIONAL) Enter the keywords longer-prefixes to view all
routes with a common prefix.
list prefix-list (OPTIONAL) Enter the keyword list and the name of a configured
prefix list. For more information, refer to the
show ip route list
command.
protocol (OPTIONAL) Enter the name of a routing protocol (bgp, isis, ospf,
rip) or the keywords connected or static.
NOTE: bgp, isis, ospf, and rip are E-Series-only options.
• If you enter bgp, you can include the BGP as-number (E-
Series only).
• If you enter isis, you can include the ISIS routing-tag
(E-Series only)
• If you enter ospf, you can include the OSPF process-id.
process-id (OPTIONAL) Specify that only OSPF routes with a certain process ID
must be displayed.
routing-tag (OPTIONAL) Specify that only ISIS routes with a certain routing tag
must be displayed.
connected (OPTIONAL) Enter the keyword connected to view only the directly
connected routes.
all (OPTIONAL) Enter the keyword all to view both active and non-
active routes.
static (OPTIONAL) Enter the keyword static to view only routes
configured by the ip route command.
summary (OPTIONAL) Enter the keyword summary. For more information,
refer to the show ip route summary command.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.9.1.0 Introduced VRF on the E-Series.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
823