• internal
level-1 (OPTIONAL) Routes are independently redistributed into IS-IS as
Level 1 routes.
level-1-2 (OPTIONAL) Routes are independently redistributed into IS-IS as
Level-1-2 routes.
level-2 (OPTIONAL) Routes are independently redistributed into IS-IS as
Level 2 routes. This is the default.
match {external |
internal}
(OPTIONAL) The command used for OSPF to route and redistribute
into other routing domains. The values are
• internal
• external
route-map
map-
name
map-name is an identifier for a configured route map. The route map
should filter imported routes from the source routing protocol to the
current routing protocol.
If you do not specify a map-name, all routes are redistributed. If you
specify a keyword, but fail to list route map tags, no routes are
imported.
Defaults Refer to Parameters.
Command Modes
• ROUTER ISIS (
for IPv4
)
• CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (
for IPv6
)
Command History
Version 8.3.12.0 Introduced on the S4810.
Version 7.5.1.0 Added support for IPv6 ISIS.
Version 6.3.1.0 Introduced.
Usage
Information
How a metric value assigned to a redistributed route is advertised depends on how on the
configuration of the metric-style command. If the metric-style command is set for
Narrow mode and the metric value in the redistribute ospf command is set to a
number higher than 63, the metric value advertised in LSPs is 63. If the metric-style
command is set for wide mode, an the metric value in the redistribute ospf command
is advertised.
893
To Next Page
Loading...
