Dell Force10 Z9000 - Page 954

Field Description
times the message interval. To reset an interface in this
state, use the fefd reset command.)
• unknown (only found when FEFD mode is normal.
• locally disabled (interface contains the fefd reset
command in its configuration).
• Admin Shutdown (interface is disabled with the shutdown
command).
Example
FTOS#sh fefd
FEFD is globally 'ON', interval is 10 seconds, mode is
'Aggressive'.
INTERFACE MODE INTERVAL STATE
(second)
Gi 5/0 Aggressive 10 Admin Shutdown
Gi 5/1 Aggressive 10 Admin Shutdown
Gi 5/2 Aggressive 10 Admin Shutdown
Gi 5/3 Aggressive 10 Admin Shutdown
Gi 5/4 Aggressive 10 Admin Shutdown
Gi 5/5 Aggressive 10 Admin Shutdown
Gi 5/6 Aggressive 10 Admin Shutdown
Gi 5/7 Aggressive 10 Admin Shutdown
Gi 5/8 Aggressive 10 Admin Shutdown
Gi 5/9 Aggressive 10 Admin Shutdown
Gi 5/10 NA NA Locally disabled
Gi 5/11 Aggressive 10 Err-disabled
FTOS#
Related
Commands
• fefd – enables far-end failure detection.
• fefd disable — disables FEFD on an interface only.
• fefd-global – enables FEFD globally on the system.
• fefd reset – resets all interfaces or a single interface that was in “error-disabled”
mode.
954